I got gifted a 2008 Kyosho Inferno GT2 and I got new glowplugs,igniter and also fuel. With a little bit of tuning the car works great until I got a new remote. I got the Spekteum SLT300 Remote. I took out the old receiver and installed the new one and every cable is connected correctly (meaning positives and negatives are in the correct spot) and I turned on the remote first and then the receiver and I noticed when I was holding the break on the remote that the servo was twitching back and forth. It wasn’t twitching a huge gap but when I would push the car it would stop move a little bit and then stop again. Before I installed the new remove the original remote didn’t have the same problem. Anything suggestion would be appreciated!