anyone got any thoughts on what kind of head pip i should get. i got a picco .26 red dot with a vantage pipe but i need a header. so is there anything out there other then stock i can use.
I'm look for a nice header and exhauset for my 3.3. Something that delivers low end. Any ideas. Also a thanx for all the previous and future help provided.
I just recently bought a Axial .28 spec1 engine and haven't got an exhaust system yet. I was wondering what the best one for the dollar would be and whats the best out there? I don't want to spend alot but I don't want any crap either. If you could give me some links to some. I have found a...
I started a thread about my slipping trans to find out that i was not even close. The inside of my factory pipe melted causing the tip to clog and make the truck run like crap.
My question is why/how did this happen. I replaced the pipe with a factory one and will be retuning the truck...
Hi, I have noticed when stopping my engine after first starting after having it out of the buggy to clean it, that it takes upto 10 seconds to stop it using this method. Also I notice a draft coming up from the engine head area which smells of exhaust. Is this normal after disconnecting the...
i am trying to fabricate a header that will allow me to run my jp-4 out of the rear of the truck where it belongs on a REVO.. I am sick and tired of airbrushing these beautiful bodies and then cutting half of them off so the pipe can be exposed.. i think If i can just get my hands on the stock...
Yo guys, I was wondering if i can make my exhuast louder? As long as it dont ruin anything, I'm fine,, so anyone know of anything?
and i dont have the money to upgrade, so dont say that.
Just finished installing my Exhaust Deflector, went for a run, and wow it wounds like a completely different buggy! I didnt think a small peice of rubber would make such a difference.
Anyone else had this happen?
Hey all, been looking on a site, found a few things I'm going to buy seeing as some i need, some i just want.
Anyway, while the engines out, I'm going to get a different coupler lol, new coloured fuel line seeing as i have some tweakeing to do to make it fit with the fuel filter.
But the point...
Does anyone have any videos of before and after installing a tuned pipe/ new exhaust on there Monster trucks? I never get to hear the difference of before and after getting exhaust for these, and i figured there has to be someone out there that has Videos of before and after. Thanks please...
well i got a gift card to the lhs and i going to get a motor saver filter and a exhaust set(header and pipe) but what do u guys recommend? and its the 3.3 and i want to keep it in the rear
So...As some of you know i broke my exhaust header and I'm looking for a new exhaust setup. Not too expensive (I've taken a lot of hits with this truck lol). So what would you guys recommend?
i need some help i want to us the os 18 tx tz motor and i don't know what would be the best sde pipe for it. i will be using the pull start that comes with the motor. i don't like bump start it is to expensive for me to buy for the revo. i have always ran the 3.3 with the jato side pipe and i...
i have a old minibike it was my dads its made for a 2-3hp engine so we stuck a 6.5hp engine on it. it hauls but i raced 4 wheelers and my friends scooters i beat them off the line every time. i has so much torqe i made a wheelie bar i use it every time i hit the gas. since i got every thaing on...
Got my truck used and it came with this:
All it says is racers edge. I can't find any info anywhere on it.
I'd like to know what engine it was made for and if it requires a special header. I got it in a lot of parts off ebay and the seller didn't know anything about it. Everything in...
I have a T-Maxx with the 3.3 with this exhaust.....
Should I be looking for a better exaust pipe? Maybe the blue Traxxas resonator pipe?
Or the chrome one?
Any suggestions will be much appreciated. I went from the old stock plastic one to the top blue one I posted here...