Hi again,
My question is two parts: first, I keep burning up throttle servos, I've broken two in the last month... any ideas as to why this might be happening? Secondly, as the title suggested I'm looking for recommendations for my next purchase of a 1/8 scale throttle servo, the last one I...
I just landed a great deal on a new SMT10 with all the goodies(not installed). I think the previous owner lost interest. In this package was a Castle Sidewinder 3 brushless set up that will be going in soon. Its got JC Renegades and I just installed Axial metal gears. My question is, what...
Hello, I really need your guys' help here. I have no idea what servo I should get for my trail finder since the stock ones are out of stock. Also, what is better for crawling speed or torque.
Tekno has just announced a set of Tekno shock standoffs, that when used with the Tekno shock bushings (TKR8730), allow the shock only to pivot between the standoff and the bushing which in turn moves the wear surface to the bushing itself and increasing the life of the cap.
Continue Reading
The new Tekno HD differential outdrives and coupler for the Tekno EB410 and ET410 have just been announced.
These new HD outdrives and couplers have less material removed to improve the durability and impact resistance, making them a perfect upgrade for bashers and even carpet racing with their...
I need to pick up a new servo to replace the stock throttle servo on my HPI Bullet that went out. I May as well replace both at the same time to save later hassle.
I’m thinking of going the Hitec route, but I’m unsure if I should go one digital and one analog, or both analog.
what are your...
Unfortunately not too thrilled with my HPI Bullet. It does run well and starts up pretty quick, but the engine doesn’t have the power for off-road I’m looking for. It’s also a pita to get a decent tune, unlike my Losi 8ight, which was a breeze to get a nice tune on.
Anyway I was looking around...
Can you put a piston and sleeve in a .18 from a .16? also is there a size limit to a nitro drift car for engine size without a whole lot of modification.
Looking for a drop in engine for my nitro 4 tec 3.3 I'm really think of doing a Novarossi 2.5 SC and Hot Racing 3 shoe clutch. Same or more power if less power only a little less than 3.3. My budget is $200 I've seen Dynamite .19 Mach 2,Ofna JL .28,Picco.26,OS21TM tell me which ones You think...
stock steering servo for the T-maxx have to replace the servo because holds the servo horn on is stripped .
What would be the best servo for me to get and Horn servo
Ordered a diff rebuild kit , grease , diff out drive cups , pipe gaskets and springs , diff seal set , trust bearing set 63 and 70 tooth spur gears , LST pads and plates
My laptop is about 3 years old, an Asus R510D with amd A-10 quad core 2.5 MHz, 8gb ram and originally windows 8. Either last summer or the year before, that bespeckled nerd, Bill Gates and his minions tricked me into installing windows 10. You know the ol "it won't be free after next week.."...
Hello everyone,
I have recently acquired a new 1/5 scale Baja 5b 30.5cc gas engine. I've purchased an upgrade on Amazon, see link below and wanted to know if anyone has any experience or opinion about using wire mess vs factory foam filter setup. It looks cool but not sure durability and how...
Hi all,
I'm new to the forum.
I'm basically after advice about batteries, I have an old RC car I would like to get up an running for my neighbors kids, I was meant to do it for Christmas but have been too busy.
Its the one in my avatar, New Bright Ford Ranger make I got given in 2002 or so...