• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

My first attempt at real fire

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
I appreciate you putting the "how to" out there Extreme. I haven't tried it yet, (its on my to do list <G>), and I like breathing the FasKolors better, but it did give me some ideas on the template useage. If you look at the SKULLZ project I did, you can see that the orange over yellow shading could have been done much better with templates.

I have two questions for you (or anyone):
*I know most of the shading is done on the outside of the template curves. Is any of it done with concave templates? and
*What is your setup for spraying Lacquers? Do you have a small spray booth, spray outside, have a fan pulling the air out, or just live with the clingy colors on your arm hairs? <G> (wearing a chemical respirator is a given)

thanks also for the airbrush recommendation. I imagine sales for the Iwata Eclipse HP-CS went up.
-Silent
 
Silent it was extremes write up that I used to do my first one you've seen here, thanks extreme. I used both inside and outside curves of the templates on mine. As far as where I shoot, I just shoot in the garage. The hard anno yellow is the worst smelling paint I have smelled in a long time, lol.
 
Back
Top