Hi everyone, yesterday I ordered a roll of hook-and-loop (Velcro is a brand that makes it), mainly to replace the 2 body clips on my buggy. You've probably seen this conversion before, where people do away with the body clips and instead stick some hook-and-loop on the side guards of the chassis (or whatever they're called, can't think of the right term right now) and the inside of the body (where the body contacts the side guards). This eleminates the need for body clips (I haven't lost any yet, still using the 2 that came with my buggy, thanks to my little Gorilla tape body-clip-retainer thing, similar to what Arrma vehicles use). The reason I'm doing this is mainly to make putting on/taking off the body easier, as it's a bit fidly, because the clips on my 1:14 scale buggy are smaller than, say, 1/10 clips, and the cold fingers (in the winter) and wires pushing against the low-profile body don't make it any easier. I plan on keeping the body posts, this way the body will sit in the same place every time I put it on. Are there any hidden disadvantages to using hook-and-loop to secure the body that I'm not seeing? Thanks!