Build Thread The Bar Crawler - Beer’s SCX24

[WickedFog]

So on these aftermarket links, are you guys running the O-ring retaining rings? They seem to be pretty limiting.

Id seen that Cape Crawlers eliminates the inner ring on his shocks to decrease binding. Wondering if the same thing would apply to the links?

These people making these links obviously don't know how to source the correct o-rings. Every set of aftermarket links I have put on these little trucks have had to be removed to peel off an o-ring. I take the inners off.

 

[Beer_Goggles_RC]

10lbs of in a 5lb sack

This motor and esc take up quite a bit of space. Still gotta figure out where to mount the battery. I'm thinking behind one of the side panels should work.

 

[Doom!]

10lbs of in a 5lb sack

This motor and esc take up quite a bit of space. Still gotta figure out where to mount the battery. I'm thinking behind one of the side panels should work.

View attachment 258635View attachment 258636View attachment 258637View attachment 258638View attachment 258639View attachment 258640

These little buggies don't leave a whole lot of space to work with, but they look cool as all get out.

 

[Beer_Goggles_RC]

These little buggies don't leave a whole lot of space to work with, but they look cool as all get out.

Possibly down the road ill do a bit of wire management to free up some space, but for now I'm pretty worn out dealing with all these Itty bitty screws and parts

 

[Doom!]

That's why the 2 in 1 motor/esc combos are nice, freeing up a bit of space is a good thing when your tight on room.

 

[RudyF6]

Can you de-case the ESC? I love my OG Furitek Lizard Pro that's just shrink tubed. Takes literally no space stuck to the side of the receiver.

 

[Beer_Goggles_RC]

Can you de-case the ESC? I love my OG Furitek Lizard Pro that's just shrink tubed. Takes literally no space stuck to the side of the receiver.

There's an idea, can't hurt to give it a shot!

 

[Antlers]

There's an idea, can't hurt to give it a shot!

Just an idea, Put a spare wheel on the back

 

[WickedFog]

There's an idea, can't hurt to give it a shot!

How much did you pay for your Furitek setup?

 

[Beer_Goggles_RC]

How much did you pay for your Furitek setup?

I didn't buy furi, just got the goup motor, esc, and metal trans for like $35