hvymetalalchmst
RCTalk Champion
- Thread starter
- #21
the pinch bolt is nice and tight, but thanks anyway, ill do that late tomorrow, but what about the flywheel problem.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Not sure how much or what color the flywheel leak is. It's a common place for leaks as they start to wear on the bearing, but it's not a major problem unless it starts to effect your tune.
Your pics really do not say much other than your ride needs a cleaning BADLY. Rotating the carb can cause a leak if not sealed and tightened properly. Also your Air Filter needs to be cleaned and re-oiled. Try these suggestions.heres a pic. i kinda dried up the hsn a little, but its supposed to be a lot dirtier. and i also forgot to mention i rotated my carby 180degrees cos the needles were impossible to get to, but i doubt thats any problem. (i know the linkage isnt right, but it works, right?)
Ill 2nd what Roxel said.
Roxel? Who the Hell is Roxel, and why would we listen to the opinion of a total stranger?
Roxel. With a name like that, he must be a real Dork.
Anyway, I also agree with Roxel as far as the Savage goes, but he also had a Tmaxx for quite a while and he never had a major problem with it.
Read my sig line. I have a permit to annoy, and I'll do it every chance I get. Sheeesh, you're pathetic, and according to your post, so is your engine. LOLok now I'm lost in the sarcasm. who is and isnt sarcastic.
i know i for one was, other than that... ???
ok. (i know most people going to be dying to say 'now theres your problem' right at the end of this sentence)... This didnt happen before i took the engine apart!!
sigh...
that means ill be taking the engine apart again. and buying a new bearing. that's time and money wasted again...