- Messages
- 1,136
- Reaction score
- 935
- Points
- 280
- Location
- New England
- RC Driving Style
- Racing
- Crawling
- Scale Builder
- Boating
Do they make a switch that wires inline with the Lipo battery terminals to cut electrical contact with the ESC?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Battery switch
- Thread starter Heisenburg
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
I haven't seen one that's RC specific. Depending on the setup, it would have to be a pretty high current switch. The esc logs from my MMX in my savage flux show 180A spikes.
Could probably use something like this, then it wouldn't hinder current flow:
https://www.amazon.com/dp/B07HT19T5V
Kind of bulky though...
Could probably use something like this, then it wouldn't hinder current flow:
https://www.amazon.com/dp/B07HT19T5V
Kind of bulky though...
LibertyMKiii
RCTalk Champion
You would ideally want to set this up on a relay that would be switched on by a typical RC switch.
Relays are built to handle current flow. A switch will melt and catch fire in a hurry.
Relays are built to handle current flow. A switch will melt and catch fire in a hurry.
- Messages
- 1,136
- Reaction score
- 935
- Points
- 280
- Location
- New England
- RC Driving Style
- Racing
- Crawling
- Scale Builder
- Boating
- Thread starter
- #4
Thanx, guys
