I have 1/5 th fg marder ,I have just replaced steering servo Futaba s3306 and throttle servo tactic tsx40 and receiver Futaba r162je and the on/off switch, I have 6.4v in battery which is a Sanyo race 2000 when checked with a volt meter. When I turn it on both servos twitch a lot and then settles eventually, when turning the steering which is not that responsive the throttle servo moves as well it’s not a lot but enough to think that it’s not right.
I also have new batts in the controller which is a W2 AR. I also have an ripmax xtra failsafe on the throttle but throttle seems worse when it’s attached. The new replaced parts were due to a power switch failure that shorted out and fried wires ,the parts I didn’t change were the chips and battery pack. When wheels are on the floor there it doesn’t seem to have enough power to turn the wheels only when they are lifted , could this be my battery pack?
I’m pretty new to this and all these bit ain’t cheap thanks guys
I also have new batts in the controller which is a W2 AR. I also have an ripmax xtra failsafe on the throttle but throttle seems worse when it’s attached. The new replaced parts were due to a power switch failure that shorted out and fried wires ,the parts I didn’t change were the chips and battery pack. When wheels are on the floor there it doesn’t seem to have enough power to turn the wheels only when they are lifted , could this be my battery pack?
I’m pretty new to this and all these bit ain’t cheap thanks guys