Steering servo probs

[POLARBEAR 3800]

I Just replaced my servo on a Arma notorious 6s and I only have throttle now and no steering what do I do to fix it

 

[CertifiedMike]

Stop!
Did you center the servo before you put everything together? If not, pull the servo arm off, turn on the radio and center the servo. Then assemble.
If thats not it, verify you plugged the servo in correctly. The correct orientation and in the right slot on the receiver.
See how that goes.
Good luck

 

[Tunedfrog]

Double check that you have the connector plugged in correctly.

 

[332_RC]

I Just replaced my servo on a Arma notorious 6s and I only have throttle now and no steering what do I do to fix it

What servo did you get?

And check all that stated above.

 

[RustyUs]

Signal wire always goes to the inside of the receiver. Of course, there is always the exception to that rule with some of the "antenna-less" ones that are out there and which way a person considers the inside.

Receiver input channels... One to turn (servo), Two to burn (ESC).

Maybe you bumped the dual/steering rate knob by accident.

Good luck.

 

[Meep556]

I just replaced my servo on an Arma notorious 6s and I only have throttle now and no steering what do I do to fix it

I literally just had this scare. So I unplugged it and flipped ot before plugging it back in. That fixed it. Hopefully, it'll work for you too.