-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Servo problems
- Thread starter thatcraig
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 2,383
- Reaction score
- 7,097
- Points
- 788
Did you center the servo before installing the horn/servo saver?
- Messages
- 1,427
- Reaction score
- 4,041
- Points
- 795
- Location
- Winnipeg, MB, Canada
- RC Driving Style
- Bashing
- Crawling
As Ritz mentioned, did you power on the servo before installing the horn?
You always need to power up a new servo and center the device out first. Then install the horn.
You always need to power up a new servo and center the device out first. Then install the horn.
I had a cat once that could only turn right. Didn't have that issue until someone stepped on its neck. Did someone step on your servo?
RustyUs
Hardcore RCTalk User
Excellence Award
Hospitality Award
Military Veteran
Build Thread Contributor
RC Showcase: 8
- Messages
- 4,162
- Reaction score
- 7,471
- Points
- 1,245
- Location
- Pennsylvania, USA
- RC Driving Style
- Bashing
- Racing
Before sending a signal to the servo to find its neutral position; set transmitter's steering trim & sub trim to center positions; Left & Right endpoints to 100%; steering/dual rate to 100%.
