• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Newbie help!! Just bought these two trucks!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
yeah I think that the one with the blue roll bar is a classic tmaxx if you were to get a 3.3 for that tmaxx you would have a screamer on your hands!!!! but one question the one with the blue roll bar is that 2wd???? i was tying to see if I saw shafts in the front but I couldnt tell..... 20 bucks unbelievable...... wheres my deal like that?????

Looks like you got just about all of it coverd you might want some spray grease or lithium grease for bearings and when you have to open up the tranny it is good to have around I ran out but normally keap some handy to keap the bearings lubed up after I wash my rigs down I use it to keap anything fom rusting and binding up............

You will definetly have a lot of fun!!!!! oh yeah the starter wand I dont know who else said something about one of them... it migh be a good idea to get a new one even if it came with one you never know what it was dropped in or on so just a helpful hint.. and always have an extra battery for your wands too...

Yeah, a 3.3 would definately be a plus! What motor have you got for the Tmaxx??? I can't quite make it out in your picture. it looks to me like your Tmaxx is 4 wheel drive, you can see the shaft going to the front diff.
 
Back
Top