studcow00
RCTalk Racer
- Messages
- 101
- Reaction score
- 0
- RC Driving Style
I'm running an ofna .26 rotostart on my 9.5V it runs ok (still really rich only 4th tank of gas) I'm using odonnell 30% but the mill likes to stall at low rpm...
its not a huge problem... say I'm driving and it stopps in a ditch, when i run to move it the motor will make a pop-hiss kinda sound and shut off... then ill put the old igniter on it and turn it over and BAM :hammer: it starts right up
I'm assuming its still too rich, runs at 180-190 degrees (i dont wanna break 210 till my 5th or 6th tank) I'm wondering if it will go away when i lean it out, or if i have my low needle at the wrong spot.
its not a huge problem... say I'm driving and it stopps in a ditch, when i run to move it the motor will make a pop-hiss kinda sound and shut off... then ill put the old igniter on it and turn it over and BAM :hammer: it starts right up
I'm assuming its still too rich, runs at 180-190 degrees (i dont wanna break 210 till my 5th or 6th tank) I'm wondering if it will go away when i lean it out, or if i have my low needle at the wrong spot.