help me to solve engine problem

[lukaa]

i bought new esc 120A and new motor 2845-5900kv surpass when i connect it to remote The engine spins freely, but when I hold the gear, it gets stuck at one point, starts vibrating, and loses power. what could be a problem

 

[tudordewolf]

i bought new esc 120A and new motor 2845-5900kv surpass when i connect it to remote The engine spins freely, but when I hold the gear, it gets stuck at one point, starts vibrating, and loses power. what could be a problem View attachment 278303View attachment 278304

That's normal, it's called "cogging", and it is what happens if you overload a brushless motor. (sensored ones can keep pushing but you shouldn't overload those either)

 

[lukaa]

That's normal, it's called "cogging", and it is what happens if you overload a brushless motor. (sensored ones can keep pushing but you shouldn't overload those either)

it doesn't move car at all

 

[C life]

Are you using the correct battery? Is it fully charged? Is your esc programed correctly?
Do you have the low voltage cutoff set for the battery you are using?

 

[lukaa]

Are you using the correct battery? Is it fully charged? Is your esc programed correctly?
Do you have the low voltage cutoff set for the battery you are using?

i dont know whats low voltage cutof I'm new in rc

 

[CreepyQuarryCrawler]

Do you have a charger?

Have you charged the battery?

If you do not have one you will need a LIPO Battery Charger capable of Balance Charging.

 

[CertifiedMike]

Thread 'Everything You Want To Know About RC Electronics'

Jul 26, 2024

Welcome to our comprehensive RC batteries and motors resource hub designed to help you get the most out of your RC experience. Whether you're a seasoned veteran or a newcomer to the world of radio-controlled vehicles, this thread aims to provide you with all the essential information and expert advice you need.

TABLE OF CONTENTS

• The Ultimate Guide to Lithium Polymer (LiPo) Batteries for RC Enthusiasts - Dive deep into the world of LiPo batteries, understanding their benefits, safety tips, and how to maximize their performance in your RC models...

• Greywolf74
• Replies: 0
• Forum: Electronics

• 
• 

You should read this, then read it again! Theres a lot of useful info in this thread.

Welcome to RCTALK.COM!!!

With the motor out of the car, does the car roll freely? No binding?

I am no expert but the 120a esc seems huge for a 2845 motor. There may be compatability issues.

What kind of rc are you installing all this into?

Is the motor the correct size for your RC?

Have any gearing or tire size changes to your RC or is it all stock?

 

[C life]

Low voltage cutoff is when your esc detects the minimum voltage of your battery. Looking at the picture of your battery i can not tell if its a 2s 3s or 4s. Usually esc's need to be programmed and calibrated. So if the esc is set for 3s and your running 2s battery it will think voltage is low. Did you follow the setup directions? Have you calibrated forward, neutral and reverse with your transmitter? Is your battery charged?

i dont know whats low voltage cutof I'm new in rc

View attachment 278308

 

[CertifiedMike]

Battery looks like 3s by the plug. 4 wires is what I see.
My 3s also have 4 wires.
There must be better markings on that battery.

Most certainly needs to be figured out before much else happens here.

I don't think a 5900kv motor will last long on 3s.