- Messages
- 1,313
- Reaction score
- 3,716
- Points
- 795
- Location
- Winnipeg, MB, Canada
- RC Driving Style
- Bashing
- Crawling
Hey Folks!
Decided instead of making a new thread for each event or prep I would just start one and keep the comp info here.
Latest event was just announced, close out of the indoor season; April 25th Final Indoor Throwdown! Epic Comp Crawl
I'll be entering the usual suspects; TRX4-M, Apex 18 and my Stance aka Faux Mullet
A few things popped up in my last event and the truck just wasn't performing up to the standards I need it too - It was hesitating going into reverse/brief pause and I have felt for a while it needs more front weight.
I had my eye on a new brass servo but for less than half the money I can put brass portal covers on and replace the pot metal.
Plus besides adding weight the 1100 has been kicking bum.
Here's what we got;
Doesn't seem like that big of a deal!
Just take this brushed setup our and reverse process!
It proved to be a little challenging!
So we got the Mamba Micro V1 tucked up as close to the front as possible on the slider, the CC BEC tied back in and the CC motor mounted up with an 11t because that's all I had that would fit. I could probably go up to a 13 but there was no way to fit the 15 tooth back.
There is also a temp sensor on the can because I have it and I am curious to monitor it during the initial few runs.
I definitely now understand why 2-1 are the preferred solutions in these things; tough to tuck it all in there, impossible to make it look good.
Next up are VP brass weights!
Decided instead of making a new thread for each event or prep I would just start one and keep the comp info here.
Latest event was just announced, close out of the indoor season; April 25th Final Indoor Throwdown! Epic Comp Crawl
I'll be entering the usual suspects; TRX4-M, Apex 18 and my Stance aka Faux Mullet
A few things popped up in my last event and the truck just wasn't performing up to the standards I need it too - It was hesitating going into reverse/brief pause and I have felt for a while it needs more front weight.
I had my eye on a new brass servo but for less than half the money I can put brass portal covers on and replace the pot metal.
Plus besides adding weight the 1100 has been kicking bum.
Here's what we got;
Doesn't seem like that big of a deal!
Just take this brushed setup our and reverse process!
It proved to be a little challenging!
So we got the Mamba Micro V1 tucked up as close to the front as possible on the slider, the CC BEC tied back in and the CC motor mounted up with an 11t because that's all I had that would fit. I could probably go up to a 13 but there was no way to fit the 15 tooth back.
There is also a temp sensor on the can because I have it and I am curious to monitor it during the initial few runs.
I definitely now understand why 2-1 are the preferred solutions in these things; tough to tuck it all in there, impossible to make it look good.
Next up are VP brass weights!
Last edited: