a pull start LRP zr.30x. here's what you need...

[ausher]

i just converted a LRP zr.30x to a pull start and maybe others may find it useful in using it in projects where one may want a pull start and not want to opt for the zr.30 spec 2.
the crank of the zr.30x has the nub to fit in the slot for the back plate one way bearing.

what I used was a LRP zr.30 spec 2 back plate part # LRP38557

and a LRP zr.30 spec 2 pull start part # LRP38556

I did try my pull start from my LRP z.28 spec 3 to see if it fit and it did, but the .30 pull start came with a spring that goes in the center of the hex nut and pull start assembly.

 

[avelciario]

yes that correct, the spring will allow the shaft not move backward.

 

[Elic]

I want to put a pullstart on a mgt 8.0..Has it ever been done..who would i need to talk to..any help would be great...if i cannot find one,,could somebody fab me one up..I will pay them to do so...thanks...