Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Yep I think that fixed now I got to figure out how to get it stopped from spinning and I don't have trigger pulled. I hate relearning radios!go into channel reverse if on the 8x
if on the 4gs or 6gs go to REV
change CH2 or TH to reverse
should be fixed
I have the rc6gsI would always recalibrate the esc if I bind a new radio/receiver or rebind it, try recalibrating and see if it fixes it.
If not, make sure throttle trims are set to 0 or center. If you have the 8X you can go into calibration and calibrate the trigger so its calibrated to know there neutral is.
I recalibrated the radio now I have no throttle at all forward or reverse??Recalibrate the radio. scroll through the menu and make sure I doesn’t have like a throttle trim turned up, with the radiolink though I can’t recall if it has something like that.
Yes I do have the manual, I'm just getting confused on the Steering being way to touchy. For my Trail it's just way to sensitive to the point of not being able to control it on my terrain. Just wasn't sure what I needed to do to slow that Steering sensitivity downOn the speed you would decrease if it’s too fast, on the expo, or a steering curve you can also decrease. Did it come with a manual? Radiolink has a good manual filled with explanations
All I know is I can't even hardly put my hand on the Wheel without the Truck darting to the left or right. That's how sensitive it is!I’d say the steering expo or curve. Go into that and bring down the low to mid ranges, and maybe just a small amount up high and try it. You can do it on the fly too, if you’re cranking the steering all the way immediately it could also be tuff to deal with, try a little bit of steering while driving. Know what I mean?
Motor direction is not the issueIf your system is non-censored just swap the two outer motor wires where the plug into the ESC. Now your motor will spin in the opposite direction. Fixed.
Got my reciever put in new Mojave 4s. I got a new radiolink and when I pull the trigger for forward it goes in reverse. And reverse goes forward. How do I get this switched??
Ohhh.This was the question I was answering.