• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Transmitter and Receiver Binding

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

RCBasher13

RC Newbie
Messages
10
Reaction score
2
Points
3
Hi, does anyone know if and how you bind an AE XP3-SSI (team associated) transmitter to an R3-2400 receiver?
 
After doing a bit of searching... is that a ZD Racing receiver? ZD Racing pops up so many times with that receiver number.

I had a few 1/8 scale ZRT-1 truggies and 1/8 scale ZRB-1 buggies years ago. They came with very privative/simplistic, but good radios. Not sure this helps but here is a picture of the radios that came with my ZD Racing platforms...
1675097708339.png

A lot RC manufacturers rebranded that same radio back then.
 
Last edited:
not going to happen they both use fhss but different protocol as said above.
 
Back
Top