Tekno ET410.2 ESC and Receiver Replacement

[WWREYN4]

I'm finishing up my ET410.2, and was hoping for some assistance on ESC/Receiver placement. I have an EZRUN MAX 10. It;s rather cumbersome trying to place the ESC and receiver in the area specified. If anyone has pictures of their placement that have been successful, I would greatly appreciate it.

 

[Bogda89]

I'm finishing up my ET410.2, and was hoping for some assistance on ESC/Receiver placement. I have an EZRUN MAX 10. It;s rather cumbersome trying to place the ESC and receiver in the area specified. If anyone has pictures of their placement that have been successful, I would greatly appreciate it.

It's not pretty but doable

 

[WWREYN4]

It's not pretty but doable

View attachment 167044

Thank you for this. It's a VERY tight fit, so i was questioning myself. Do you think you could put the receiver in the rear?

 

[bill_delong]

This is a 120A V3 from HW, it's about the same size at the Max10

 

[RustyUs]

Thank you for this. It's a VERY tight fit, so i was questioning myself. Do you think you could put the receiver in the rear?

Sometimes you just gotta do what you gotta do...

 

[WWREYN4]

Sometimes you just gotta do what you gotta do...
View attachment 167058

How did you mount the antenna on the back? That is the route I'm leaning.

 

[RustyUs]

WWREYN4, I used E6000 to attach antenna tube, receiver, and the on/off switch. Love that stuff.