Rc compatability

[Reece Holman]

Would a hobbywing 3652sl 3250kv combo, work with a 3s lipo on a 1.8 diameter 16teeth pinion?(120 amp esc)

 

[theRCLLAMA]

Just check the size of the shaft diameter and double check the pitch on the stock pinion and you will know. That is a 3S capable motor and esc yes.

 

[DavidB1126]

Yes
Just for reference the size of the shaft is 3.175mm so 1/8 is close to it, should all work together no issues.

I have the same combos but I run on 2s and 4000kv and they rip.

 

[theRCLLAMA]

Yes
Just for reference the size of the shaft is 3.175mm so 1/8 is close to it, should all work together no issues.

I have the same combos but I run on 2s and 4000kv and they rip.

Nice I just picked up the Hw 3150kv Hw 10bl120A hoping that rips too

 

[Reece Holman]

Just check the size of the shaft diameter and double check the pitch on the stock pinion and you will know. That is a 3S capable motor and esc yes.

It is the stock pinion on the rc car, I will check the shaft diameter now thank you.

 

[theRCLLAMA]

It is the stock pinion on the rc car, I will check the shaft diameter now thank you.

No prob Ya Google the pitch of the pinion

 

[Reece Holman]

Yes
Just for reference the size of the shaft is 3.175mm so 1/8 is close to it, should all work together no issues.

I have the same combos but I run on 2s and 4000kv and they rip.

Yeah I can't wait I just wanted to make sure, as I brought a esc and motor from a hpi Firestorm, and used a 3s and the esc set on fire i guess next time I will do more research when getting into a new hobby.

 

[TeknoJ]

Yeah I can't wait I just wanted to make sure, as I brought a esc and motor from a hpi Firestorm, and used a 3s and the esc set on fire i guess next time I will do more research when getting into a new hobby.

Yikes, time to invest in an infrared temp gun. Check motor and esc temps after a few speed passes or a couple minutes of driving. Stay out of the grass, it just causes the electronics to gain more heat.