Radio Helppp :(

[david41990]

soo the sun finally came out here in L.A and I decided to run up my Nitro only one problem the servos, or the receiver wont turn on all the batteries are new and all the cables are ok non are ripped or torn up.. its not wet because i did turn it on about three weeks ago just to turn it on and it worked soo what could it be??

 

[Rolex]

Bad connection, defective switch, or you left it on and the batteries are now stone dead.

 

[david41990]

hmm it could be one of those things except the batteries i changed those

 

[CharliesTheMan]

Have you unplugged any of the wires since you turned it on last, because maybe you plugged the servo wires into the receiver backwards. I did that once for about 1 second, and in that one second I fried my switch, melted my battery holder, and darn near fried everything else. Sounds like it may be the switch. If it didn't get wet, it's either the batteries or the receiver or switch. Have you put the batteries in another high drain device to make sure they were good?

 

[david41990]

yea batteries are new ahhh idk I've tried everything i guess maybe something is fried i hope is just the on off switch

 

[Rolex]

Bypass the switch and just plug the battery pack directly into the receiver. If it works, then you know the switch was bad. If you get the same thing then the switch is good, and the problem is elsewhere.

 

[olds97_lss]

Not to poke a stick at the obvious but how are the batts in the transmitter? Is the crystal in transmitter and receiver seated properly?