project bash worthy Revo

[syphon68]

Well after spending 3-4 hours at the skatepark destroying my Revo last week I decided totally go through it and make it more bash worthy so I took it apart and installed the following.

RC solutions cage
FOC conversion
rebuilt front and rear diffs
New RPM arms all the way around
Engine brace
aluminum steering brace
2 new tires
resonator single chamber pipe
exhaust manifold
single steering servo Hi tech
new chassis

It took a couple of days to get it this far but I like it so far.

 

[olds97_lss]

Looks like your header and pipe don't line up quite right.

I'd pick up these for the pipe:
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXUTG4&P=ML
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXUTF5&P=M

Much more durable since the spring allows the header to give on impact instead of snapping it off at the flange where it mounts to the engine.

 

[Bryson]

I think he just needs to move the mount up a little. The pipe just looks like its mounted to far down the wire. If stocker short you can make a new one out of a coat wire really quick. But the spring mount header will be better for bashing anyway.

 

[syphon68]

My custom coat hanger muffler mounts appears to fubar. I am going to fab one up tomorrow from piano wire then zip tie the heck out of the rubber. since that one is new I will wait til its gone.

 

[KevinGalusha]

Cage makes that thing look BEEFY!