New servo doesn’t work.

[raptor170]

Hi, I got a new servo for my tt02. When I turn on the car and connect my transmitter the wheels turn full left. When I try to steer the servo moves a bit then goes back to full left. I adjusted the steering endpoints and the trim but it does nothing. Do you what is happening? Thanks!

Also the pervious servo worked fine

 

[DavidB1126]

Did you center the servo before putting the servo horn on when installing the new servo?

Try this:
- Take the servo out
- Take off the servo horn (or saver)
- Power on the car with endpoints at 100 and trims at 0 so the servo can center itself
- Put back on the horn/saver upright and install servo
- Reset endpoints, use trim to trim it out if needed

If we try that, it should work, if not it could be the servo but most likely won't

 

[332_RC]

This ^

 

[raptor170]

Did you center the servo before putting the servo horn on when installing the new servo?

Try this:
- Take the servo out
- Take off the servo horn (or saver)
- Power on the car with endpoints at 100 and trims at 0 so the servo can center itself
- Put back on the horn/saver upright and install servo
- Reset endpoints, use trim to trim it out if needed

If we try that, it should work, if not it could be the servo but most likely won't

Thank you!