My New AX10

[MCNorris]

Ok not NEW but new
I added:
Sidewinder
86'd the edge for a stock chassis
new lower links all around
threw in a BEC
Went LIPO
I got MIP's but I think I'll just add the front one because they wont work with my rear DIG.

Anyway I'm done for now!
Old

New

Done for now, Candyman is painting to body so that should be on soon, I need to clean up the wires a bit more, and find a permanent place for the battery and ESC

 

[slowngreen]

lookin good man!

 

[abadk9420]

Comming a long nice, I think I would chacge out the rear axle to lockouts though, less stuff to break that way...

 

[MCNorris]

Yea I am not sure to get STRC lockouts or AXIAL's opinions?

 

[slowngreen]

they are both nice imo, since I've always liked strc-id say go with them.

 

[WoodiE]

The pictures are a bit blurry so I'm not really making it out, but where or what are you mounting your ESC and receiver to?

I don't plan on using the battery tray but not sure where I'm going to put everything when I build my AX10.

 

[slowngreen]

well, let me jump in here and say, on top of the upper links woodie. just make a little tray outta some lexan. you can cut it out of a soda bottle or some kinda of wrapper that is like that, just cut it into a triangle to fit on top of the uppers and zip tie it on.

 

[Rolex]

Mine has custom side rails, but the setup is similar. Double face tape and a zip tie. One for the ESC and one for the RX. No plate needed.
There's a lot of available space between the rails, and it adds the weight closer to the front tires.

 

[abadk9420]

well, let me jump in here and say, on top of the upper links woodie. just make a little tray outta some lexan. you can cut it out of a soda bottle or some kinda of wrapper that is like that, just cut it into a triangle to fit on top of the uppers and zip tie it on.

Or you can get these for just a few bucks
http://www.tcscrawlers.com/TCS-Craw...xial-AX-10-Scorpion-clear-2-each-p-17116.html

 

[MCNorris]

I was going to do it on the back too but my DIG is in the way, I think I am going to mount my battery in between the body posts, behind the EEM bar. I'll have to see how the body sits like that though.