The fan mounts on my Castle Monster X 8s ESCs keep breaking off. Is there a solution beyond just replacing it with another stock one?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Monster X 8s issue.
- Thread starter Ramp addict
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 476
- Reaction score
- 1,192
- Points
- 210
- Location
- MN
- RC Driving Style
- Bashing
- Crawling
- Flying
- Boating
You mean aside from sending it like it's an airplane. Yeah, probably not.
Looks like a piss poor design on Mamba's part. Not to mention the larger fan. That's not helping you. Any way to sneak a zip tie or wire on that end to keep it from snapping when you take a hard hit?
Looks like a piss poor design on Mamba's part. Not to mention the larger fan. That's not helping you. Any way to sneak a zip tie or wire on that end to keep it from snapping when you take a hard hit?
Tunedfrog
Kermit the frog is a sissy.
Supporter
Excellence Award
Hospitality Award
Military Veteran
Build Thread Contributor
RC Showcase: 10
- Messages
- 17,392
- Reaction score
- 37,845
- Points
- 1,875
- Location
- Idaho
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
Zip tie if you can get it in there.
- Thread starter
- #4
What I have ordered is a replacement cover and a M2C carbon fan brace. What I would like is a 3D printed fan mount made of the same stuff 3D RC makes their wing mounts out of. I have seen them on Arrma builds before so I know they exist, I just don't know who makes them.
