• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

majins SCT410-2.0

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
A flashing LED on receiver? Figuring out why it's not solid would be my first priority.
The led was flashing because both the servo and the throttle wires both popped free
Once I connect the throttle to any of the ports it is solid
The esc I THINK is flashing because it's not re Irving throttle input from the reciever
I can't enter calibration mode
All that added makes me think is bad reciever
The same.controller is boundnto two other vehicles and they both accelerate
So it's not c9ntroller
Steering works and I get power no matter which other port I plug throttle into
So it's not getting signal
This would make the esc flash the throttle error I'm getting
 
The led was flashing because both the servo and the throttle wires both popped free
Once I connect the throttle to any of the ports it is solid
The esc I THINK is flashing because it's not re Irving throttle input from the reciever
I can't enter calibration mode
All that added makes me think is bad reciever
The same.controller is boundnto two other vehicles and they both accelerate
So it's not c9ntroller
Steering works and I get power no matter which other port I plug throttle into
So it's not getting signal
This would make the esc flash the throttle error I'm getting
Can you swap out receivers to test?
 
Can you swap out receivers to test?
all my recievers are tied up, and the one i ordered was for a different controller and it wont bind to my fsgt3b and its for an NB4. fml, reordered the one i always get tho so ill know in a few days
 
At least you'll know in a few days. So weird though that it would have fried from a slide!
I wonder if it was just the way the wires fell out when the crash happened???

Glad you got it narrowed down!
I'm thinking it had to do weith the servo/throttle wires popping out yeah, hopefully i didnt fry this expensive esc lol
 
I hope not too!
How did those wires pull out of there? Did the receiver come loose on impact?
Maybe other receivers are different but mine are tight fitting plugs to the point of almost inconvenient.
Maybe they just weren't pushed in all the way?
 
I hope not too!
How did those wires pull out of there? Did the receiver come loose on impact?
Maybe other receivers are different but mine are tight fitting plugs to the point of almost inconvenient.
Maybe they just weren't pushed in all the way?
I'm guessing they weren't fully seated but its silly weird
Was not a hard impact at all lol
Will know in a few days
 
I'm guessing they weren't fully seated but its silly weird
Was not a hard impact at all lol
Will know in a few days
No, I saw the video. It wasn't a bad hit at all. Thats why I asked.
I didn't know if there was something else going on here.
It seems like maybe just loose and they came undone.
Yup, we'll see! 👍🏻
 
Or from repeated 'mild' hits... maybe they crept a bit with each one, until they popped out.
What are you insinuating sir??? What? That i drive like a drunk child? That I spend more time wrecking than I do driving?
What that I'm irresponsible?
What exactly sir ARE you trying to say?????
Also mild hits don't count so there


But yeah most likely lol
 
Sounds like something Bill Clinton said once...
"I didn't inhaaaaaaaaaaaaaaaaale!"
Well judging from the stain on her dress, Monica didnt swallow so who knows maybe he told the truth there? 🤣 🤣 🤣
 
What are you insinuating sir??? What? That i drive like a drunk child? That I spend more time wrecking than I do driving?
What that I'm irresponsible?
What exactly sir ARE you trying to say?????
Also mild hits don't count so there


But yeah most likely lol
Guilty on all counts, are we both! :hehe:
 

good times, i swapped the reciever. we have throttle!!!!!
however lost steering??? wtf
in the other reciever the steering works but no throttle... i believe i got it wetter than it could handle. turns out the reciever in the tekno was grey... smh greys arent waterproof the blues are... so i most likely got some water sprayed up into it
but now in this new waterproof reciever i got no turn... wtf
 

good times, i swapped the reciever. we have throttle!!!!!
however lost steering??? wtf
in the other reciever the steering works but no throttle... i believe i got it wetter than it could handle. turns out the reciever in the tekno was grey... smh greys arent waterproof the blues are... so i most likely got some water sprayed up into it
but now in this new waterproof reciever i got no turn... wtf
The good news is, soon you will be able to trouble shoot anything. Just keep those new problems comin' and you will become super edumacated! 🥸
 
The good news is, soon you will be able to trouble shoot anything. Just keep those new problems comin' and you will become super edumacated! 🥸
Try plugging a different servo in. Does it move?
so since it didnt work i thought to myslef... Majin.. (i refer to myself in the 3rd person) i think Majin, what would the guys do..... well theyd hook up a receiver that they know works, and see if they get steering response..
so i did that and guess what???
 
so since it didnt work i thought to myslef... Majin.. (i refer to myself in the 3rd person) i think Majin, what would the guys do..... well theyd hook up a receiver that they know works, and see if they get steering response..
so i did that and guess what???

You done been teached real good! 🤣 Glad you figured it out, won't be long and we will be coming to you for answers. :thumbs-up:
 
Back
Top