LCRacing LC12B1- The Shapeshifter

[TeknoJ]

You and me both, homie.. That was on the list of first priorities when a couple EMB-T’s were the plan.. I’ve had extremely good results with the EZ-OFF method.. It’s also documented in one of my build threads if ya end up going that route, or want a refresher.

I witnessed it all go down. That was pretty neat, then it was “dead on ballz”

 

[OnwardGuinevere]

Love the shapeshifter builds! This is exactly what I'm striving to do with my Associated LT10SW. I want to be able to switch between SCT and buggy so I have options for the track. So cool!

100% agree with red anodized parts. My least favorite as well.

 

[Littlemotor]

I witnessed it all go down. That was pretty neat, then it was “dead on ballz”

Ha! That’s right! You were definitely spectatin’ like a boss!

 

[TeknoJ]

Love the shapeshifter builds! This is exactly what I'm striving to do with my Associated LT10SW. I want to be able to switch between SCT and buggy so I have options for the track. So cool!

100% agree with red anodized parts. My least favorite as well.

It’s pretty neat when a platform can do that!

 

[TeknoJ]

Ha! That’s right! You were definitely spectatin’ like a boss!

These Idaho folks though… I called 4 places today that advertise aluminum anodizing, not one actually does it. Ok, it’s on your website my guy, did YOU even know that?!

 

[Littlemotor]

These Idaho folks though… I called 4 places today that advertise aluminum anodizing, not one actually does it. Ok, it’s on your website my guy, did YOU even know that?!

I ran into the same… If you’re on Fakebook, shoot ”Tekno Ti” a message. Might be able to help ya out.

 

[CertifiedMike]

https://sendcutsend.com/blog/diy-anodizing-in-10-steps/

If you feel like getting crazy...

Steps look pretty straightforward if you have a good area to do it in.
Doesn't look like anything too tough to source.

 

[TeknoJ]

https://sendcutsend.com/blog/diy-anodizing-in-10-steps/

If you feel like getting crazy...

Steps look pretty straightforward if you have a good area to do it in.
Doesn't look like anything too tough to source.

Nutz!

 

[TeknoJ]

Design #2 on the receiver box!

 

[TeknoJ]

I think a 3.0 is coming, this is a very tight fit. I need to shrink the width by a few millimeters

That’ll do for now donkey.

 

[TeknoJ]

This thing is so fun, these cheap Amazon tires are an absolute blast on the street. Plenty of grip, yet a little slide into the turn action too. So cool. The go pro was not filming the entire time
@Littlemotor you need one of these, you don’t have to get 3.

Side shot Saturday here we come…

 

[TeknoJ]

A little garage floor drifting?