i need some help

[apla]

the engine is a 12Tr engine with 11a carb and pilot crankshaft
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXCNA3&P=0

teamtrinity sais i must put an engine rear exhaust small block w/ slide valve carb(and nothing else)
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXEUV3&P=0

are they compatitive with each other ? or i am facing a problem with the pilot
crankshaft ? :shrug:


thank you

 

[olds97_lss]

Is what competitive with what?

Is there an instruction manual link somwhere that you know of to build the kit? A lot of times, they show how to install the clutch/flywheel/clutchbell and you can see what kind of shaft they intend for you to use.

I did some looking at trinity's site to see if I could find a manual... I couldn't.

But I found 2 kits that came with engines, the g4 racer and g4 pro. The g4 pro uses this engineBlack Pixi 12 w/Pilot Shaft

The engine for the racer kit, I couldn't find. But the pro kit engine is a pilot/SG shaft like the OS you want to buy.

 

[apla]

mayby i didn t exlain very well


the g4 racer kit can take this engine(12TR 5port with a pilot crankshaft)?

thank you in advance

can i find anywhere on line a manual for the g4?

 

[olds97_lss]

Didn't realize you were from another country either... your questions are more like a statment presenting facts than a question looking for an answer. I was confused...

I edited my original post on what I found at trinity. I know nothing about on-road, but I thought I'd try to help as I've used a lot of different engines in my 4 years of off-road.

 

[apla]

ok thanks anyway!! i think i have found the answer i was looking for!....i am so lucky!at last it seems that the engine fits on my car!!!!!!!