• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Hpi savage f4.6 carb problem low speed not setting

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Eray

RC Newbie
Messages
2
Reaction score
0
Points
26
I changed carb the problem still continues, the sound is bad please help. I wonder if there is a crack in the block

car video

my english is bad so sorry
 
Did you tune it. I never trust buying a new carb and putting it on. Sounds like the low is too lean. Winter is the worst time to run and tune a nitro engine. Start with the stock needle settings and then look for air leaks. Usually around the exhaust or engine backplate.
 
Did you tune it. I never trust buying a new carb and putting it on. Sounds like the low is too lean. Winter is the worst time to run and tune a nitro engine. Start with the stock needle settings and then look for air leaks. Usually around the exhaust or engine backplate.
ım tune perfect but this problem auto low speed lean and rich problem screw fixed ı dont know this problem :( my engine performance very good
 
All needle settings are set to flush setting. If the low is rich turn it in 1/8 turn at a time. This carb has 3 needles Only mess with the low if it is rich off the line.
 
Back
Top