Help What does cannot be recovered mean here?

[>BD]

I have it on a crawler, so it is hard to tell when it is on 50% power. My min voltage on the battery label is 6 volts. I am paranoid.

 

[>BD]

Mine refers to table A

 

[WVNed]

It simply means that the model will be dead until the battery is charged again. No position of throttle will allow the model to move again.

 

[>BD]

It simply means that the model will be dead until the battery is charged again. No position of throttle will allow the model to move again.

Ok, I thought that it was mean the battery was permanently ruined when the cutoff was activated.

 

[tntpoof]

lvc does not harm battery.. it protects the electronics on the rc... but the 6 volts is way to low of a voltage to take a 2 cell lipo to(you will have to bring each cell up on nimh mode at 1 amp charge thru balance wire..

 

[>BD]

lvc does not harm battery.. it protects the electronics on the rc... but the 6 volts is way to low of a voltage to take a 2 cell lipo to(you will have to bring each cell up on nimh mode at 1 amp charge thru balance wire..

What would be a good device that would make a noise when it gets to something like 6.5 volts?

 

[tntpoof]

a programable lipo alarm..
https://www.smc-racing.com/index.ph...ls haven’t reached the desired cutoff voltage.

 

[tntpoof]

id be aware that some lipo chargers will not see a low voltage lipo... you will get errors trying to charge.id check to see the lowest your charger can charge from and set alarm at that voltage(I hope your following me.)

 

[tntpoof]

you see a lipo will have what i call a bounce back voltage (varies from pack to pack) but its about .02 volts max.if you stop at 7.0 volts when you check battery after a few minutes voltage will be a little higher than the 7.0 volts alarm was set at.

 

[>BD]

you see a lipo will have what i call a bounce back voltage (varies from pack to pack) but its about .02 volts max o stop at 7.0 volts when you check battery after a few minutes voltage will be a little higher than the 7.0 volts alarm was set at.

I never have gotten he battery down to 6 volts or ever had the cutoff activate. I have this charger https://www.amainhobbies.com/radient-reflex-lipo-20w-balance-charger-us-rdna0066/p501582

 

[Rolex]

It simply means that the model will be dead until the battery is charged again. No position of throttle will allow the model to move again.

Who the hell was THAT?

 

[tntpoof]

batman

 

[>BD]

Who the hell was THAT?

?

 

[Rolex]

?

I'm messing with @WVNed. Haven't seen him here in quite a while.