having some problems

[godale03]

Hey guys,

As any of you here that know me, know that sometimes I have some big luls in the time that I get to spend with my RC's..... well I have been working on a Jammin X1 CR for a little over a year now. In fact I have been working on it so long, that the X2 is now out! Anyway, I have two main problems.... Now keep in mind, that everything here is still brand new... I have an Orion reciever pack that now will not charge at all.... shows as having no juice and will not take a charge. Is there a way to fix this or just get a new NiMh hump pack? Second, I have an OS .21 V-spec mill that is so tight I can't get it to turn over at all. This motor has never been run and is brand new. Any suggestions? Thanks guys.

Tom

 

[2revo1maxx]

The pack should take a charge, but you'll have to find a charger with some kick to it. The engine should also be ok. Take a heat gun and very carefully get it up close to 200 degrees.

 

[beason]

hook the pack up to some lights and see if they glow.. it may have discharged all the way down and is really dead. you can try a trickle charge to wake it up..

the engine, I'm with him.. get it hot, loosen the glow plug, and see if it will turn then.

 

[Metalhead Matt]

I've revived dead rx packs by giving them a fast jolt from a 6 cell charger. Just for a second or two. Then charge it normally. After a few cycles, you'll know if it's good or not.

 

[godale03]

Alright cool. I will give it a shot.... except it is supposed to rain all weekend here! Figures