Emaxx help??

[*madmaxx3.3*]

I have the new 16.8 v emaxx. I've recently been having problems with it. I turn the evx-2 on with fresh charged batteries and the light on it goes red and the emaxx has no respose, and if you mess with the controller a bit the light goes green and it randomly full throttles backwards forwards and everything inbetween. It will occasionally get control but barely and if I do the controls are reversed forward is backward and backward is forward. Is this a reciver problem? A little of the antenna was chopped off like a centimeter. It also is a new evx-2 only got one run on it. Thank you in advance

 

[Metalhead Matt]

Sounds like the channel 2 switch on the tx needs switched. Then use the trim to get the esc back to neutral(green light).

 

[abadk9420]

Sounds like you might want to also reprogram the esc as we'll after you get your settings right on the controller.

Sent from my SCH-R720 using Tapatalk 2

 

[*madmaxx3.3*]

Is the tx the transmitter? How do you switch the channel 2? And also how do you reprogram the esc? Also i already got the trim right but it still goes crazy. Sorry I'm kind of new at this and thanks

 

[trax de max]

I'm guessing you have the Link

If it is the link click here
It's all about counting the blinking lights.

If you come to a mistake reset it to the default profile and start again.
Make sure batteries fully charged in truck and Transmitter. (yes any transmitter Tx, any receiver Rx).

You should re-program the esc too. see below
For the evx2 manual clicky me