I set up my DX3S for my REVO last weekend. I used it yesterday and it worked fine. Today I started things up and my LED on the DX3S was not working. Well, working but so dim I could hardly see it. Am I missing something like an on/off, or dim switch (DUH), or do I have problems?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
DX3S LED Not Working?
- Thread starter tapplbrn
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Low battery maybe?
- Messages
- 35,104
- Reaction score
- 1,854
- Points
- 2,198
- Location
- In my recliner
- RC Driving Style
- Bashing
- Flying
Is the radio working properly as far as sending correct signals to the receiver? Can you walk a good distance and still move the servos on the car? Don't start the engine till you can verify that it's working.
- Thread starter
- #5
At first the servos would barely move the steering and throttle. I adjusted the steering rate and got the steering working. I dug into the setup and adjusted the contrast and the LED came back. I know for sure that it was working fine when I put it up the night before and me or no one else changed those settings????? I did a “model reset”, and just got back from running it and setting the steering and all back up again. Works great!!!??
