Drake .12 in a XXX-NT

[m1marty]

Just impulse:green-grin: bought a Drake/Trinity .12 for my XXX....now I need to know what I need to install it. Header/pipe I'd guess and....? I *think* it should mount up in place of the stock Mach .15 (from the research I've done anyhow). Does anyone make a shaft start backplate for this mill? I don't have a bump box, and don't care for pull starts much either.

 

[kyosho138]

There is a starter box that is made for the xxx-nt that goes for about 100 bucks. It had enough to turn over my o.s. TZ during brake-in.(after a little help with a screw driver)

 

[kyosho138]

I just ran across the part number for the starter box the part number is 'A99060' and it is 109.95 at nitrohouse.com