Did I do this right?

[pissant]

Well when i put the throttle linkage on my vspec .21 engine. I had to take the carb thingy and put it on backwards so the throttle linkage didnt have to be the long. is this ok, its hard to explain, its the piece you can remove form the engine, where the LSN and the HSN is? I just had to switch it so the O.S. logo on it was facing the engine, would I have problems doing this? I have the mp777 if that helps :fro:

 

[CorradoPsi]

yes on most engines you have to rotate the carb for buggy use. the slide should be pointed towards the servo.

 

[pissant]

ok thanks, yea i thought so, lol

 

[PiErow]

Ya on 1/8th scale buggies you have to rotate the carb 180 degrees.

 

[Plaidfish]

Hey on 1/8scale buggies you have to rotate the carb....I just wanted to post that too

 

[vbgagnon]

Just in case you didn't know...you have to rotate the carb.

 

[retarded pilot]

forget what those hacks told you........you have to rotate the carb in a 1/8 buggy

 

[CorradoPsi]

wheres lessen, he needs to get in on this...............

 

[beason]

hey man I'm not sure but i think you may have to rotate the carb if your gonna be putting it on a buggy.. I'm not sure.. i may be wrong.. just thought i would post that since NOONE else has..

 

[wannarunem]

hey pissant dont take all this poop from them...tell em to sit on this and rotate....:flamer: LMAO!!!!!!!



start at post #20 in this thread...it may help ya.....

https://www.rcnitrotalk.com/forum/showthread.php?t=29030

 

[bsodmike]

I just figured that today my self. Now in the Kyosho manual it shows the ball link facing down-forwards, but mine is up-backwards (towards the rear)...can this be moved?

 

[mikeburgin]

yeah little grub screw on the side of the sleeve to adjust the ball link
Oh and yeah turn the carb 180 to fit buggy

 

[ZANDOR]

Man why do you guy feel the need to screw with him???
pissant just rotate the carb 180 and you will be cool :shrug:
Or is it 190 or 240????maybe 260

 

[Buggyracer28]

Maybe if you rotate the carb 540, it will work better. :shrug: Forget about 180, the more you spin it, the better it works. lol

 

[Nathan_454]

I think you need to turn the carb 180 degrees.

 

[bsodmike]

haha!

I've already turned the carb but there is a screw head on the side of the ball head, does this allow it to be repositioned?

 

[bsodmike]

OK - sorted! Found the grub screw that is on the other end of the ball head...not even mentioned in the manual lol!

 

[bill61]

Hold the carb still and rotate the buggy 180 degrees. This is the easiest way to do the linkage connection, and the best.