-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Considering a 1/10 scale crawler
- Thread starter Tallbump
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Thread starter
- #222
My buddy was taking done bashers out to the gravel pit/township area where you can dump rocks, branches, etc...by my house.
I remember that there were some rock piles when we've gone before so I grab my rig along with my Redcat Volcano 16
I also drilled new body mounting holes
I did end up losing a wheel. Well it fell off, I did find it. Apparently I didn't do a good job attaching the hub to the wheel and all but one screw fell out. But up until that point I was very very happy with how this thing performed. Way better than I expected it to. Incoming photo dump
I remember that there were some rock piles when we've gone before so I grab my rig along with my Redcat Volcano 16
I also drilled new body mounting holes
I did end up losing a wheel. Well it fell off, I did find it. Apparently I didn't do a good job attaching the hub to the wheel and all but one screw fell out. But up until that point I was very very happy with how this thing performed. Way better than I expected it to. Incoming photo dump
- Thread starter
- #223
Got a couple of videos too
Blue loctite is your friend for those pesky wheel screws
