• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Check out my 4s Rusty

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Pfaulk54271

RC Newbie
Messages
2
Reaction score
2
Points
3
Location
Parrish, FL
Weve had this truck for over 10 years, first run on this power system will be this afternoon.
??
 

Attachments

  • received_945345429139873.webp
    received_945345429139873.webp
    100.8 KB · Views: 114
  • received_1045612242315757.webp
    received_1045612242315757.webp
    87.3 KB · Views: 101
  • received_325982598113645.webp
    received_325982598113645.webp
    102.1 KB · Views: 107
  • received_179685126244618.webp
    received_179685126244618.webp
    63.2 KB · Views: 110
  • received_272302857056730.webp
    received_272302857056730.webp
    152.7 KB · Views: 106
  • received_376271719765319.webp
    received_376271719765319.webp
    164.5 KB · Views: 113
  • received_635489040195779.webp
    received_635489040195779.webp
    124.1 KB · Views: 108
  • received_544838355922068.webp
    received_544838355922068.webp
    134.8 KB · Views: 112
Very clean setup. Can't imagine those slider axles on the rear will hold up too long. When I converted my eJato, I was running 2S with the traxxas 3500kv motor. The axles lasted 30 seconds. Then the plastic single speed conversion lasted 2 minutes.

Now that I have traxxas cvd's and a steel single speed conversion, it holds up well to 3S and a 3200kv 3660 motor with trencher 2.8's on it.
 
Very clean setup. Can't imagine those slider axles on the rear will hold up too long. When I converted my eJato, I was running 2S with the traxxas 3500kv motor. The axles lasted 30 seconds. Then the plastic single speed conversion lasted 2 minutes.

Now that I have traxxas cvd's and a steel single speed conversion, it holds up well to 3S and a 3200kv 3660 motor with trencher 2.8's on it.
I'm sure they're gonna disintegrate when I put the power to em. The MIPs are waiting in the wings. FLM makes the best CVDs for Rusty but they're costly. By spring time, they'll be in place on Rusty.
 
Back
Top