1st build electronics question

[primebeatz]

I have a Flysky Receiver Gt3b and I connected my electronics like this:
VCC connected to BEC which is connected to Mamba ESC to battery connection.
Bind CH3 is white cird from Mamba ESC
CH2 BT B Link connected between Mamba ESC
CH1 is to Savox servo

Does that seem right?

 

[Greywolf74]

I dont understand half of what you typed there.

First question. What rig and which Mamba are we talking about here?

Your BEC should be hooked up like this.

Not sure what you have hooked up to CH3.

CH2 should be the ESC although you have to remove the red wire from the center of that plug or youll damage your RX/ESC. See pic above.

CH1 is correct for the servo

 

[tntpoof]

no if you have a bec then esc center wire needs to be removed from rx plug as it will cause esc to burn up.and I have no idea what a B link is?..

 

[WickedFog]

no if you have a bec then esc center wire needs to be removed from rx plug as it will cause esc to burn up.and I have no idea what a B link is?..

Castle bluetooth module to setup the esc.

 

[Greywolf74]

The B link is fine but the Red center wire needs to be removed from the plug that plugs in to the receiver. Normally this would be done one the ESC plug but since you have the B link in there it needs to be removed from the b link connector where it plugs in to the receiver.