Who Makes These?

[AClegg]

There is a guy trying to find out who made these wheels. They look to be vintage. I think they are custom made, but... Have any of you seen these before and know who made them?

TNT,
I figured you would be the man to answer this one.

 

[tntpoof]

clueless here.. think I did see them once on a super Beatle? not sure?‍

 

[AClegg]

Every time I look at these I think of a mass airflow sensor on a full-size truck.

 

[biggman100]

There is a guy trying to find out who made these wheels. They look to be vintage. I think they are custom made, but... Have any of you seen these before and know who made them?

TNT,
I figured you would be the man to answer this one.

3D printed for an Associated RC10? Carved from a solid vintage buggy wheel?

 

[AClegg]

3D printed for an Associated RC10? Carved from a solid vintage buggy wheel?

I think it was machined. I don't think they had 3D printers back in the early 90's. Then again, after looking closer, you can see where they shaved off the excess where the plastic was injected into the mold. Therefore, these were not machined, they were molded.

 

[monstertruckier15]

They were RPM vintage wheels.

 

[AClegg]

I tried looking under RPM and could find anything. Did you use to have them?

 

[tntpoof]

post a link monster beat you can't