Leo.177
RCTalk Basher
credit to this thread for the recommendation: link to thread
Sorry to disappoint the people who helped me but this is what I went with:
A Konect RS8 Elite esc with a K8 Elite 4274 2200kv motor.
To be honest I was a little scared to buy these electronics because I needed to solder the motor and esc by myself. But to my surprise it went well. I have only soldered connectors before so this was my first time with motors/escs. Any opinions on the soldering? (basically the same quality of soldering on the esc)
Picture of the esc:
The next upgrade will be a new steering servo and aluminium servo arm. This is the servo I think I will get:
SRT BH6027
Specs:
7.4V
25kg/cm<-->347oz/in
0.08 sec
Price: 60€<-->63$
After that I will get the second part of the motor mount as right now it just acts as a motor brace. There is space between the mount and the motor that is filled with some medium-hard foam.
Sorry to disappoint the people who helped me but this is what I went with:
A Konect RS8 Elite esc with a K8 Elite 4274 2200kv motor.
To be honest I was a little scared to buy these electronics because I needed to solder the motor and esc by myself. But to my surprise it went well. I have only soldered connectors before so this was my first time with motors/escs. Any opinions on the soldering? (basically the same quality of soldering on the esc)
Picture of the esc:
The next upgrade will be a new steering servo and aluminium servo arm. This is the servo I think I will get:
SRT BH6027
Specs:
7.4V
25kg/cm<-->347oz/in
0.08 sec
Price: 60€<-->63$
After that I will get the second part of the motor mount as right now it just acts as a motor brace. There is space between the mount and the motor that is filled with some medium-hard foam.
