Traxxas Sledge - Engine Cooling

[JamesB2]

Traxxas Sledge
Looking to cool the engine. I 3D printed this (https://www.thingiverse.com/thing:5854833)

It's designed to hold two 40mm fans. My question is which fans should I use and how do I wire it into the receiver?
Should I go with something like this and purchase the "Y" spliter? (https://www.amazon.com/2Pack-16000RPM-Cooling-Brushless-Heatsink/dp/B0BC3SG9VR?th=1)
On the receiver, which channel should I plug it into?

 

[DavidB1126]

Depends on how many extra channels you have on the receiver. You can plug in the fans on any extra channel besides 1 and 2. Or you could just get a y splitter or a servo extension and just plug in the fans there. (same if you do it with the splitter, any extra channel on the receiver)