THS racing pipe and header?

[joneser4u]

Has anyone used a THS pipe? I have had trouble finding a pipe with the pressure fitting in the proper location for the RS4 3ss,I have a CVEC but had to put a skrew in the origanal pressure fitting hole and redrill a hole and move it,my wife will inherit the ol 12R engine header and the CVEC pipe for her RTR 3,I found the THS pipe and header at towerhobbies just for the HPI RS4 3,wish I knew how to post a link to it,Hopefully someone can give me some info on the company since I've never seen or heard of them? it has the rubber gasket and spring header to pipe hookup opposed to the silicone boot POS,will it fit my new OS .15 CVR-X mill?

 

[NCNitro]

I have it on my RS4 3 now, I will be doing a full review on it soon. I have not even had time to run it yet. As soon as I get a chance to test it out I will post pics and results.

RD Logics also makes a one piece tuned pipe for it too.

 

[joneser4u]

KOOL, THANKS ALOT!!

 

[LarryA]

I have the THS on my NRS4-3SS and it works real good. I can't say for improvement over the factory pipe because I never even put the factory pipe on the car. The only thing I have found is that you must cut your body opening large enough that the pipe cannot touch the lexan. The lexan, with virabtion, will eventually cut through the aluminum sidepipe section.

 

[joneser4u]

I ordered it? Hopefully it will be a good performer,if not I just spent 50$ on a good header!:trashed:

 

[Rex2342]

It's a very good pipe.I noticed the difference in power right away when I put it on my Fantom fr15.I can barly cotrol my SS as it is and with the new pipe it's even worse lol.

 

[joneser4u]

good to hear,I've recieved and installed it but its hard to say how it performs on a new engine?break-ins suck!!!!:dance: