Teremoto V2 steering problems

[Kjanora100]

Both steering servos that I have do not respond when being in channel 2

 

[Kjanora100]

I just tried it

 

[Kjanora100]

And yes I plugged them in the right way

 

[Kjanora100]

I just tried and both my steering servos do not respond when in channel 2. And yes, I plugged the wires in properly.

 

[tntpoof]

sounds like radio steering pot is bad.. contact seller of rc see if you are in warranty or buy another radio (if it was me Id go with another brand)

 

[Kjanora100]

The steering pot is that silver round thing that you can see right. Also the throttle works good when you control it with the steering wheel on the controller. So does the steering pot not get used while the throttle servo is being controlled by the wheel? If it is used then it's not the steering pot.

 

[BobP]

I would recommend a new transmitter and receiver.
I have a Spektrum 3 channel with 3 channel receiver I'll sell for $30. It came on my new Capra but was never used.

https://www.horizonhobby.com/produc...3-channel-24-ghz-fhss-radio-system--spmstx300

 

[Kjanora100]

You thing it's the transmitter then?

 

[BobP]

I think it's the receiver

 

[Kjanora100]

It can't be because the throttle runs great in channel 1

 

[Kjanora100]

I would recommend a new transmitter and receiver.
I have a Spektrum 3 channel with 3 channel receiver I'll sell for $30. It came on my new Capra but was never used.

https://www.horizonhobby.com/produc...3-channel-24-ghz-fhss-radio-system--spmstx300

Will this work on my car

 

[BobP]

Yes

 

[Kjanora100]

Can you send the link to that controller

 

[BobP]

Look at the post above

 

[Kjanora100]

Ok guys this is something important that I found. Plz look at this. So I took the gearing apart in both my service and when I plugged it in and turned it on the gear that the red arrow is pointing to spins to the left and doesn't stop. This happened to both my servos so it's not the steering servo. What could be causing this to happen?

 

[Kjanora100]

And it only does it when the controller is on. When I turn the controller of it stops spinning. When the transmitter is on it spins only left. But when I try to steer right it slows down the spinning slightly but it does stop it completely from going left.