Welcome to RCTalk
Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
fstnd
RCTalk Addict
- Messages
- 530
- Reaction score
- 835
- RC Driving Style
- Bashing
I've often heard people putting thin paper between the gears but when i did that the distance between the gears was always too big...
The way I always did it is just "gambling" by repeatedly moving the gears slightly to eachother untill it's too much and then I back out a little
The way I always did it is just "gambling" by repeatedly moving the gears slightly to eachother untill it's too much and then I back out a little
Jpslash667
RCTalk Racer
- Thread starter
- #3
No like, these screws on the motor and trans are set. It's like I can't adjust anything. I'm new to the nitro side so If I'm missing something please show me.I've often heard people putting thin paper between the gears but when i did that the distance between the gears was always too big...
The way I always did it is just "gambling" by repeatedly moving the gears slightly to eachother untill it's too much and then I back out a little
Tunedfrog
Kermit the frog is a sissy.
Supporter
Military Veteran
Hospitality Award
Build Thread Contributor
Start this video at about 1:00
tntpoof
Whats Up Doc?
- Messages
- 4,404
- Reaction score
- 2,276
- Location
- Taylor Michigan
- RC Driving Style
- Bashing
- Racing
- Flying
- Boating
You also need the correct tools for the JOB at hand.
