I recently purchased a rustler 4x4 VXL and I love it. I have noticed my spur gear slipper assemble and the whole I put shaft can slightly move back and forth between the rear diff and the motor plate bearing the come sleeve goes in to. It has about 2-3mm of movement, it will slightly pull the bearing out of the motor mount enough to see it. Nothing is broken all bearings are good etc but I do wonder about this being normal tolerances or not. It seems that if I put some sort of shin on the end of the shaft then goes in to the rear diff it would fill that movement gap, of even a slightly thicker bearing, one that sticks out of the motor mount slightly.
My hope is this is normal and nothing to worry about or maybe I got a bum i put shaft length. Any advice is greatly appreciated!
My hope is this is normal and nothing to worry about or maybe I got a bum i put shaft length. Any advice is greatly appreciated!