Rubbing on the PCR Pro

[jon2]

Ok I decided to change the c hub in the front to the PBS style. I am not too happy already with the directions with this kit but now I can't seem to steer at all!! The Upper anti squat is rubbing on the aluminum sttering bar that holds the turnbuckles. I am pretty pissed already and I need you PCR pro owners some help. what the hell is wrong?

 

[jon2]

Help:constipat

 

[itsme]

C Hub

That was one of my problems with the POS Violator i Have it already has a weak servor so rubbing on that plastic stop didnt help one bit my next buggy going to have PBS.:redbuggy:

 

[dgrobe2112]

i think you need to change shock tower.. and chassis braces.. front steering brace as well.. big difference between the PBS, and C-hub.. also your arms will be different as well..

just wanted to make sure you knew that before you tried to pull of the c-hub and put the pbs on there..

 

[jon2]

I figured it out. I had the hinge pins on the wrong hole . PLus I went ahead and countersunk the screw and inverted the screw so it would be flush into the counter sunk hole. Lol I screwed that one. Still not happy with the instructions.

 

[itsme]

C Hub

I'm Going to try putting the MBX front and rear section on the Violator its not going to be as wide as it was but I'm not to concerned about that i just want something more durable IMO
so to sum it up I'm going to have a MBX Violator. Have A Nice Day:cheeky:

 

[jon2]

OK I did all that and I still feel some binding somewhere and am not sure where to look. The binding casued my srevo --645mg to strip the servo . I also tightened the spring on the steering assembly. SHould I have done that? Where else can I look? I am really getting tired of this buggy. No drive time yet!!!

Steering Servo arm I meant. Lol