Ross dont get it

[marv02]

I am new at this stuff so sorry if this a easy fix I don't get it.

I have a new T Ten Truggy I ran 1 tank though it the glow plug has gone bad ran another tank with a know good glow plug and now it will not run unless the Start button on the controller is pushed in as soon as you release the button the car dies.

With the glow plug out of the motor you can see the glow plug is working get nice and red.

I tried to reset the factory needle setting still the same.

I just don't understand what causing this or how to fix it.

I have ordered a couple OS A# glow plug but they will not show up for a couple days from now.

help.

 

[Rolex]

Lean out your LSN setting.

 

[marv02]

Nope

Thanks I gave it a try still the same it wont run unless the starter button is pushed in.:\

Lean out your LSN setting.

 

[marv02]

Looks like the Glow plug is fried again and it running lean what causing me to cook the Glow Plugs.

 

[Zdragon71]

Running too lean will eat plugs up like candy. Shutting off when you remove ignitor means its too rich. You have to make small adjustments until you see the performance coming back. Follow this tuning guide for best results.

http://www.extremercmods.com/content/tuning-popup.html

 

[marv02]

Thanks for the link I give it a try when my new glow plugs show up.

 

[NHB_RC]

Did you make sure your idle gap was good? Sounds lean to me also.. Check for leaks if it's still doing it at stock needle settings.