• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Revo 3.3 Nitro rear brake and slipper clutch eliminator

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
75brick

75brick

RC Newbie
Messages
3
Reaction score
0
Points
26
So...I pulled my old Revo out of storage and started running it again..I bought a rear brake kit for it but the rear shaft is too short and is missing the hole where the pin should go. I'm guessing I need a different one...also I bought a slipper clutch eliminator wlbut that does not work either...sticks out too far...what's going on?

Thanks!!
 

Similar threads

CreepyQuarryCrawler
Revo 3.3 Seized
2 3
Replies
47
Views
937
ohsnap
O
G
kyosho stadium truck clutch and bell
Replies
11
Views
279
fstnd
fstnd
C
Revo 3.3 rebuild issues
Replies
4
Views
391
Lukedavis
Lukedavis
yfzracer450
Brake linkage
Replies
6
Views
397
Suburban_Hooligan
Suburban_Hooligan
Roog
Centrifugal clutch for larger nitro engine?
Replies
18
Views
719
Roog
Roog

RC Builds

Back
Top