RC sound simulator installation in non RC car model.

[Yerffoeg12]

I have an old wooden model landrover (12 inches length) with no electrics. I have a acquired an RC engine sound simulator

https://www.banggood.com/Second-Gen...CN&p=DI25096070388201608B&custlixnkid=1270478

There was no tech sheet with the package. I want to install this in the wooden model. I obviously need a batter (voltage?). How else do I go about it? I dont mind if the engine stays on tickover. This is for my grandson. I have no knowledge of RC models or the electrical connections!

YOUr suggestions please.

 

[WickedFog]

That just needs a 6v power source.
Tenergy NiMH Receiver RX Battery with Hitec Connectors 6V 2000mAh High Capacity Rechargeable Battery Pack for RC Airplanes/RC Aircrafts and More https://a.co/d/flIxoDE

But without a radio system, I don't think it's going to make any noise. Pretty sure throttle input from the radio turns it on.

 

[bill_delong]

You can adjust the engine rev using a servo tester for the dial to control the engine sound in place of a radio:
https://www.amazon.com/DIYmall-Digital-Consistency-Controler-Checker/dp/B012LZKTDO

 

[WickedFog]

You can adjust the engine rev using a servo tester for the dial to control the engine sound in place of a radio:
https://www.amazon.com/DIYmall-Digital-Consistency-Controler-Checker/dp/B012LZKTDO

That's a good idear!

 

[Yerffoeg12]

Many thanks for the replies!

GEoff