Rc 18t problems

[PiErow]

Every single time i run the drive shaft pops out of the out cup. I am running cvds and it still does it. How do i fix it?

Also my suspension is relly sagggy and loose. I'm going to put heavier oil in it but what are a good set of springs?

 

[BADNBADN]

Go to ace hardware and purchase 4 5/16 brass compression and slid them over the outdrives. This will hold your cvd's from flying out. Hope this helped. Heres A pic.

 

[PiErow]

No offense but learn how to focus...
What kind of tires are you running? They look huge!

 

[PiErow]

Can you get the sleeve online?

 

[bashaholic]

I replaced the front springs with a set of rear springs, seems to work a little better.

 

[Northlander]

the 5/16" brass compression sleeves can be purchased from most hardware stores, after installation you may need to crimp with a pliers to keep if from falling off. I too would like to know what kind of tires those are.

 

[savagelover12]

they look like touring car tires because there big and because of the thread.

 

[ZANDOR]

I have never seen one of thoese rides..But do they have droop screws???so you can limit the suspention travel..That whould help keep them in :shrug:

 

[Spokane HobbyTownUSA]

Cut a ballpoint pen spring in 4's and put on piece in each outdrive to push the bone into the cup. Like a MIP CVD